Build an EV charging wall panel in Home Assistant through the HA MCP server

A new Rivian R2 owner had Claude, connected through the Home Assistant MCP server, build two garage tablet dashboards for the car and a 40 A OCPP charger over a couple of evenings.

Done withClaudeinHome Assistant· Nov 17, 2026

What they did

The poster, u/Jackald1918, took delivery of a Rivian R2 and a 40 A charger that speaks OCPP, and wanted a wall-mounted Fire tablet in the garage showing the whole charging session at a glance. They connected Claude to their Home Assistant through the HA MCP server. Claude read the real entities from the unofficial Rivian integration and the OCPP integration, then wrote and edited the dashboards live. The poster reviewed screenshots of the tablet and fed notes back each round. The result is two dashboards: one for the charger with start and stop buttons styled like emergency stops, needle gauges, cost and energy readouts and a current slider, and one for the car with tire pressures, battery level and charge rate graphs. Two small custom JavaScript cards and a wake-on-motion automation tied to a Frigate camera finished the panel.

How it went

It took a couple of evenings. The poster published the full YAML, both custom cards, a session cost sensor and the automation as a gist so others can copy it. They list the snags they hit: OCPP caps current at 32 A until you raise it in the integration settings, the charger only reports its body temperature, and the Rivian integration can read the charge limit but cannot set it. One round of Claude's edits was silently lost when a stale dashboard editor tab was saved over it.

Worth knowing

Close any open dashboard editor while the agent is editing, or saving the old tab will overwrite its work. The poster also warns that a 40 A charger is a continuous load that needs a 50 A breaker and matching wire before you raise the limit. Entity names in the shared files are generic and need a find and replace.

Try it

With Claude· 7 parts to fill in

Using the Home Assistant MCP server, read the entities for my [car integration] and my [charger integration] and build a new dashboard for a wall tablet at [screen size and orientation]. Show the live charging session: start and stop controls, current, voltage, power, energy added, session cost at [my electricity rate] and elapsed time, plus graphs for the last [number] hours. Add a second view for the car with battery level, range and [other vehicle data I care about]. Use only these frontend cards: [list of installed custom cards]. Create new dashboards and do not change my existing ones. After each round, wait for my screenshot and notes before editing again.

Square brackets are the parts to fill in. The prompt is ours; the story is theirs.

Where they said it

Related